Amcrest Forum

So I am not sure if this is an issue with the camera or if this is a software issue with Amcrest or not. I mean my Ad410 siren works so I would think if it was a Software issue and contact with the Servers that neither of them would work. So then I will admit something that did worry me a little when Installed the MSD is the placement and function of access. With my snow this winter I wonder if maybe the camera has water damage and why it won't turn on the siren? I tested with my Wifi and I tested on my Cell wifi and both fail to start the siren. I can still access the light on the app.

Anyway anyone other then me have an issue with turning on the Ash26 siren?

I'm having the same issue.

when i try to activate the sire in the app it give me a warning, then a message that says "Talking Now"

consequently, when i try to use the talk function is is also not working.

firmware is up to date and everything else seems to be fine.

While we're at it.. .this is still an issue, even with the brand new ash26 i installed last week the siren does not work on motion detection or manual activation.

I can't say. I would if I were you start with 2 things. 1 reboot the camera. and try again. If that don't work reinstall the Firmware and test again. I know that I had some issues with it some time ago. I mean it has been over a year and that isn't an issue now. I can make it go off with no issues. Now I will admit at times I have to reboot the camera when I try to make some dog leave the area where I have my camera installed. However once I reboot the Siren works without fail today. So not sure why you are having issues. As I said first off I would reboot the camera.