Page 1 of 1

NVR Viewing-1 Modes, cannot cycle through installed cameras

Posted: Sat Oct 12, 2019 12:12 pm
by bataradena
I'm just starting to set up my new NVR Model NV4108E-HS.
What I'm trying to accomplish, just like my old retired CCTV Analog Blue Iris system, is how to automatically "cycle through" or to scrolling through "three" POE Security Cameras, one at a time using the "NVR viewing 1 Mode."
I like to have this way so I can see the monitor across the room.

I'm hoping this software feature is available, I just cannot figure out how to set it up.

Byron in Tucson, AZ.\

Re: NVR Viewing-1 Modes, cannot cycle through installed cameras

Posted: Sat Oct 12, 2019 3:11 pm
by Revo2Maxx
Hello and welcome to the Forum.

So I am not 100% that it is in there but I would look for a Camera Tour Option. Not to be confused with PTZ tour.

Re: NVR Viewing-1 Modes, cannot cycle through installed cameras

Posted: Mon Oct 14, 2019 7:17 am
by bataradena
After reading you reply I found this link, "Hint-on-how-to-setup-the-tour"
https://amcrest.com/forum/nvrs-dvrs-f19 ... r-t98.html
Reading the posting replies this seems to be the fix, or should I say a working around.
I'm hoping for the next software update this issue will be address to make it more user friendly! :roll:

Re: NVR Viewing-1 Modes, cannot cycle through installed cameras

Posted: Mon Oct 14, 2019 9:12 am
by jack7
Here's another way to to do what you want. Use Amcrest Surveillance Pro- Tour & Task to easily set up and use a repeated cycle through your full screen NVR camera views at user specified intervals. It requires attaching the NVR to your LAN and using your PC.
https://support.amcrest.com/hc/en-us/ar ... -and-Tours