Limited to single channel at 30 fps?
Posted: Fri Jun 14, 2019 6:55 am
Hello Amcrest community. Is anyone aware how to change all my channels to stream 1080p @ 30 fps? I have the AMDV10814-H5 DVR, just received it yesterday in fact to replace a unit that died unexpectedly that was nearly 3 years old. My first channel is set to 1080p @ 30 fps, but channels 2-4 are at 1080p @ 7 fps. There isn't even an option to go higher than 7 fps.
What's up with that? Any insight would be appreciated. Thank you.
edit. I just tried to set channel one at 7 fps to see if that allowed a different channel to encode at 30 fps. This DID NOT allow that change to happen. This seems to suggest this may be a mistake in the device firmware. Can any Amcrest individuals comment?
What's up with that? Any insight would be appreciated. Thank you.
edit. I just tried to set channel one at 7 fps to see if that allowed a different channel to encode at 30 fps. This DID NOT allow that change to happen. This seems to suggest this may be a mistake in the device firmware. Can any Amcrest individuals comment?