I just purchased an NV2108 and have successfully hooked them up to my Sercomm icamera2 cameras via rtsp. Of course controlling camera settings doesn't work, but I expected that and can login to the camera remotely.
Now, the icamera2 will send an http GET/POST command when motion is detected, but I cannot figure out the API command to trigger the motion detection event on the NVR. I've scoured the Amcrest API and surely there is a way? or a custom hack or something?
Discussion for all types of camera
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests