Amcrest Forum

Again James, thanks. Did verify that snapshots are enabled on the NVR under Storage - Record. Just to force it, disabled and saved, then enabled and saved, exited the screen and went back to it to verify. One thing I did find that on the NVR using the WebUI in Management: Camera - Encode - Snapshot ...

James, thanks so much for the detailed response. Still no luck... Went through the WebUI using Chrome, and followed the steps. Found that Camera - Storage - Schedule - Snapshot Schedule, I only saw yellow (Motion) and red (Alarm) bars; had to drill down deeper with the Setup in that screen to select...

Have the NVS4108E-HS (firmware 3.215) with 4 amcrest 4K cameras attached. Was configured to take a snapshot every 60 seconds on each camera (in addition to saving the video). HDD is configured to overwrite on full. This was working perfect for about 9 months, then occasionally after the weekly reboo...

For cameras hooked up to NVR via PoE, you have to access the camera's Web interface. You must 1st access the NVR using "Internet Explorer" not "Edge". Go to Settings, REMOTE DEVICE. Click on the IE icon under the Browser column. It will open the Web interface of the PoE cameras....