I am having trouble with one of my IP3M-943 cameras.
I had it connected wirelessly and it kept losing connection [even though it is only 20 feet from router], so I ran a [new] cat cable and hooked it up.
It is also hardwired electrically by a proper voltage adapter that has been checked and is working properly.
The problem is that I tried to hard reset it to get it setup after I wired it and it won't reset.
It goes through the reset stages of the lights flashing and finally seeing the red and green solid, but it does not stay there [red & green solid], it always stays there for a minute or so and then flashes red and then solid red. I have tried a few times but it is always the same.
It does not show up on the config tool and only showed the 1st time on the nvr but I could not change anything.
What could be the problem?
Is there anyother way to reset the camera?
Have some questions or having issues with your IP Camera(s), Post them here for the mods and other users to assist you with.
1 post • Page 1 of 1