IP8M-2943EW Fails after three days
-
- Posts: 2
- Joined: Fri Oct 01, 2021 6:06 pm
IP8M-2943EW Fails after three days
Approximately 3 days after reseting the camera it stops working. I can't access the GUI or see video. Camera doesn't disconnect from NVR, but shows a black screen. The camera works normally after cycling off and on. But after about 2 or 3 days malfunctions again. The firmware has been updated. Anybody have any solutions.
-
- Posts: 2
- Joined: Fri Oct 01, 2021 6:06 pm
Re: IP8M-2943EW Fails after three days
Also forgot to mention, this is the second camera (same model) that is doing the exact same thing.
Re: IP8M-2943EW Fails after three days
Hello and welcome to the forum
Sorry to hear your having some issues. So to try an clear up some info that is missing.
NVR a Amcrest or different brand?
On your NVR do you have it log you out after a set time?
You using these POE or Secondary Power source?
So I would look to see if your using H265 and if you are I would for testing change that to H264h and see if that cures the issue. Also are you using full 8mp or did you scale it down?
Sorry to hear your having some issues. So to try an clear up some info that is missing.
NVR a Amcrest or different brand?
On your NVR do you have it log you out after a set time?
You using these POE or Secondary Power source?
So I would look to see if your using H265 and if you are I would for testing change that to H264h and see if that cures the issue. Also are you using full 8mp or did you scale it down?
Be Safe.