650TVL

[ramharakh]

Hello,

can someone help me on the installation of 650 TVL.

i plug the power cable of the DVR and power led goes on but the HDD light does not light up.
by connecting the VGA cable with by Monitor, only the Amcrest Logo shows but there is no Interface.
can someone help me

regards,
Ramharakh

[Melvin]

Hello,

You may need to initialize the hard drive for first time use. For this, you need to login to the DVR settings and go to HDD manage and click the Init button. But I see that you are unable to get to any of the DVR settings? This might be because the DVR's video output resolution does not match with your monitors'. You could try a different monitor if you have. Also take a look at the below tutorial that explains the resolution problem.

https://amcrest.zendesk.com/hc/en-us/ar ... ppear-NVR-

[ramharakh]

when i turning the dvr on the amcrest only apears on the screen than it goes blank and after that it just lose signal

[ramharakh]

iam really desperate now
1 time i plugged the ps and the dvr kept restarting where the amcrest bootup appears no further
so i have no interface and my monitor autom adjust the resolution so no problems there. if it was a resultion problem i think the bootup would even apear.
and now when i plug the PS in the dvr bootsup till the amcrest logo and then gose blank and lose VGA signal i tried restting still no changes i dont hear any beep or anything/

Thanks in advance

[Melvin]

Hello,
We would be more than happy to help you fix this issue. Could you please contact our support team though phone or email?

https://amcrest.com/contacts