Anytime I log into the IP of my NVR on my computer, and go to adjust settings (motion detect, etc) it doesn't always show the correct channel, making it extremely difficult to complete this.
Furthermore if i go to the setup - remote device and load up the individual camera (I know which is which). Log into that specific camera, it doesn't necessarily show the corresponding channel feed.
Any idea what i've done wrong, or is this just a bug with the software?
Thanks!
Incorrect Camera Shown on Computer Login
Re: Incorrect Camera Shown on Computer Login
Anybody? Same problem still 5 months later....
Re: Incorrect Camera Shown on Computer Login
Hello WarmPepsi,
From the NVR settings, go to System > And set the NVR to factory settings and then re-add the cameras. This should correct the issue.
From the NVR settings, go to System > And set the NVR to factory settings and then re-add the cameras. This should correct the issue.