I have an Amcrest1080p.
I set up the wifi for it successfully at my desk and near the wireless router. After that I need to move it to a different place within my house (about 30yards away), of course, when I move the camera, I must disconnect the AC plug. When I plug the AC plug back in a the new location, the camera will not pickup the wifi signal because its memory might be wiped out by not having power when I unplugged the AC. Any suggestion? Please help.
How to move and reconnect after set up Wifi
-
- Posts: 2
- Joined: Fri Apr 22, 2016 6:03 am
Re: How to move and reconnect after set up Wifi
it shouldn't lose settings because of being unplugged.
are you sure the setup completed successfully?
If you are using WIFI to do the setup, you can do that at the location you plan to put the camera.
Did you use the Config software to verify your initial setup?
are you sure the setup completed successfully?
If you are using WIFI to do the setup, you can do that at the location you plan to put the camera.
Did you use the Config software to verify your initial setup?