Amcrest ad-110 flashing blue then green - No hotspot

This Forum its to discuss the new Smart Home Devices.
Post Reply
Superczar
Posts: 2
Joined: Mon Dec 05, 2022 1:40 pm

Amcrest ad-110 flashing blue then green - No hotspot

Post by Superczar »

I got a new amcrest ad-110 from amcrest direct.
Powered it up on the bench but cannot get it to activate hotspot.

On powering up, it lights up in solid light blue for some time then goes into a blinking pattern of “dark blue - off - green -off” that repeats itself.
Pressing the reset button momentarily has no effect and holding it for 10 seconds results in a voice prompt that says resetting device. After this, the device reboots and goes back to the initial loop.

Could not find any reference to this LED pattern either on amcrest support or manual .. or on the forum.
Any thoughts would be appreciated.

Please note that I am not in the US and returning it under warranty will have to wait at least 3-6 months till I visit the US again - so i have a strong incentive to try all possible troubleshooting before I try claiming warranty.
Post Reply